Pinion Seal - Toyota Land Cruiser, 4Runnner, Hilux - 9.5" & 8" diffs - (38x74x11/19mm) - 90311-38047

Pinion Seal for Toyota Land Cruiser, Hilux, 4Runner 9.5” & 8” differentials.

This seal is also used as a Transmission and Transfer Case output seal in some applications.

Seal Dimensions: 38x74x11-19mm

Pro Tip: If you have a crush sleeve style differential, it is a requirement to replace the crush sleeve when replacing the pinion seal.

It is very difficult to get the pinion preload correct when doing this in place - be very careful, and try to use a little less than the recommended factory level of preload with used bearings.

Over-tightening the preload on a used bearing will lead to rapid pinion bearing failure.

Toyota Special Service Tool (SST) 09556-22010 is designed to help easily remove the pinion bearing from the pinion shaft so that the outer race can be removed to get the old crush sleeve out and a new one in place. The outer race can be removed using a few different methods, but a 2 or 3 jaw puller and slide hammer can work really well.

Toyota pn:
90311-38047

also subs from these part numbers:

• 90311-38028
• 90311-38035
• 90311-38049
• 90311-38066
• 90311-38133
• 90311-38134

NB: There are several different seals in the later production years for the Land Cruiser and other models when the pinion size & spline count was increased - check your part numbers carefully to ensure you are purchasing the correct seal.

90311-41009 = 41mm ID
90311-45028 = 45mm ID

Toyota OEM - NOK brand - Japan

8484.20
0,046
alternates
98168 - Kelpro
082-022395
9031138047 
9031138028
9031138035
9031138049
9031138066
9031138133
9031138134