Washer, Flat - Toyota Land Cruiser, Hilux steering knuckle stud - 90201-12019

Steering Knuckle Stud - “hexalobular” (=has 6 point male torx at the top for tightening into place).
Toyota pn:
90126-12010 (current pn)
90126-12005
90116-12007
Toyota - Japan

Cone Washer for Land Cruiser & Hilux steering knuckle. Toyota calls this part “dowell, split (for steering knuckle arm)”
Toyota pn:
42323-60020

Nut for Steering Knuckle Stud, drun brake backing plate & other high strength applications. Land Cruiser, Hilux & othersM10x1.25
Toyota pn:
94115-71200 plated
Toyota - Japan

Swivel Hub/Knuckle Kit - Land Cruiser 70 Series High Pinion 8" 08/1989-07/1999
DT-SH5

DT-SH4 Swivel Hub/Knuckle Kit
Fits all Land Cruiser models from 1981 to 1989 with Non-High Pinion front end.
Fits Toyota 4WD mini-truck w/solid front axle & Hilux LN106 solid front axle pick up trucks.

Swivel Hub/Knuckle Kit for Land Cruiser 80 Series & Lexus LX450 with the 8” high pinion live axle front end:
FJ80, FZJ80, HDJ80, HDJ81, HZJ80, HZJ81, LX470

These are the correct Koyo knuckle (aka trunion or king pin) bearings for your pre-1990 Toyota solid axle vehicle. Toyota part number:
90366-17001
90366-17007
90366-17001-77
Made in Japan

Knuckle /Trunion Bearing - Land Cruiser 70 & 80 series 09/1989 - up
Toyota pn:
90366-20003

For front and rear locking hubs, drive plates, and rear full floating axle shafts that use 8.0mm hub studs. Hub Stud Kit:
1x 8x1.25mm Stud
1x 8x1.25mm Nut
1x 8mm Lock Washer
1x Cone Washer

Toyota pn: 90116-08325
Made in Japan by Joint Fuji