|Availability:||In stock (3)|
This kit can also be used for the 13BT, however it does not contain the turbo gaskets, and the valve cover gasket will not be correct (it's no longer available from anywhere). There is no longer a 13BT specific kit available at this time.
The head gasket supplied in this kit will withstand fairly high boost levels when installed properly; I have had one in my personal BJ74 since 2010 running a max of 16 PSI and it's been great!
The turbo gaskets for the CT26 turbo on the 13BT are the as for the 1HDT, except that you will need an extra oil supply pipe gasket. Use GTMTO350 and add one of part number 15471-58010 to your order.
Head Gasket (composite)
Valve Guide Seals (8 pcs)
Valve Cover gasket & grommets
Timing Cover gaskets
Oil Cooler / Filter Housing gaskets
Front & Rear Main seals
Intake & Exhaust manifold gaskets - metal composite
Thermostat & Water Neck gaskets
Breather Cover gasket (cork)
Oil Pan gasket (cork)
Copper Washers & O-Rings
Does NOT come with injector seals/washers (see related items below):
Other recommended items, not included:
- Pre-combustion chambers (3B only)
- Injector Seal Washer set (see above)
- Injection Pump O-Ring (pump to timing cover housing) (90301-77001) - currently this is listed as no longer available from Toyota
- Thermostat 90916-03103 (88C) or 90916-03102 (82C)
- 39 Pc. Freeze plug set
Cylinder Head bolts should be re-torqued once only to 87 ft-lbs after run-up and full cool-down is allowed for.
note: these part numbers are no longer available from Toyota
Engine Australia -
2022 06 14
04111-58090 = 13BT full engine gasket kit