| Article number: | DT-DBK6 w/Factory Locker (e-Locker & Cable Locker) |
| Availability: | Out of stock |
Please scroll to read this product description contains important installation information attached in pdf format.
This kit does NOT contain: the shims that may be required to set-up your pinion gear depth, nor does it contain the shims to set-up carrier gear position (backlash) and bearing pre-load. These parts are available separately.
Kit Contents:
• 2x Carrier Bearing 90366-60002 - Note: these carrier bearings are 60mm i.d.
• 1x Rear Pinion Bearing 90366-40059
• 1x Front Pinion Bearing 90366-30038
• 1x Pinion Seal 90311-38035
• 1x Crush Sleeve 41231-60030
• 1x Pinion Stake Nut
• 1x Differential Carrier to Housing Gasket
• 1x Gear Set-up Paint (does not come with brush)
Genuine Japanese Koyo bearings in kit
Notes about completing a differential bearing replacement or re-gear:
Other parts are going to be needed to complete a differential bearing or re-gearing job; here are suggestions for additional parts to order.
1. On rear differential applications, you will need or want, rear axle shaft gaskets and inner axles seals at the very least.
• 70 & 80 Series rear axle seal kit (1990-on manufacture) DT-HSK30
• 60 & HD 70 series rear axle seal parts (before 1990 model year)
• Wheel Bearing Seal 90311-62001
• Inner Axle Seal 90310-35001
• Hub Gasket 43422-60010
• Hub Stud & Cone Washer Kits (8x1.25mm) 90116-08325K / FTL-395
Alternatively, you can use a wheel bearing kit that contains the seals and
• 1990-on =
• before 1990 =
2. On pre-1990 60 & HD 70 Series models that use the 9.5" differential in the front axle, you will probably want to order a knuckle rebuild kit
Installation Information:
• Rear Full Float axle removal and installation instructions (pages for 1990 & later Land Cruiser 70 & 80 Series)
• Rear Differential set-up information (pages for 1990 & later Land Cruiser 70 & 80 Series)