Dust Cap, Front Axle Outer Flange (hub cap) - 43423-35010

For front and rear locking hubs, drive plates, and rear full floating axle shafts that use 8.0mm hub studs. Hub Stud Kit:
1x 8x1.25mm Stud
1x 8x1.25mm Nut
1x 8mm Lock Washer
1x Cone Washer

Toyota pn: 90116-08325
Made in Japan by Joint Fuji

Gasket, Drive Plate/Hub Flange 80 series (multi hole)
43422-60030
43422-60060
Aftermarket

Replacement Birfield CV Axles for the Land Cruiser 80 Series with ABS.
Toyota pn:
43405-60070 = 246.5mm
43405-60060 (pn for shorter part that this replaces 238.5mm)
ABS ring is not supplied
Made in Taiwan

Swivel Hub/Knuckle Kit for Land Cruiser 80 Series & Lexus LX450 with the 8” high pinion live axle front end:
FJ80, FZJ80, HDJ80, HDJ81, HZJ80, HZJ81, LX470

Knuckle Spindle - Land Cruiser 80 Series, HD 70 Series (w/coil front end) w/bush & needle bearing
43401-60041
43401-60080
43401-60081
Japan

Drive Flange, Front Axle - Land Cruiser 80 Series with longer splines.
43421-60040
Toyota OEM or Joint Fuji - Japan

This kit replaces the two 54mm nuts, the thrust washer, and the locking tab (aka: ‘star washer’) on Toyota Live Front Axles.
Kit Contents:
1x 90215-42025  “Star” lock Washer
1x 90214-42030  Thrust “Claw” Washer
2x 43521-60011  54mm Spindle Nuts

Wheel Bearing Kit, Front & Rear - Land Cruiser & Hilux Full Floating axles
NB: excluding rear disc brake models

Birfield for the Land Cruiser 80 Series. Non-ABS.
Later version with the longer splined section to replace short splined versions that suffer spline/drive flange wear.
Toyota pn:
43405-60080 (246.5mm)
Engineered in Australia - Made in Taiwan