Crush Sleeve - Toyota 8" Rear & 8" High Pinion Differentials

Article number: P-6581
Availability: Out of stock
Crush Sleeve for rebuilding the Toyota 8” Rear and also the 8” High Pinion Differentials with or without E-Locker. Any time you loosen or remove the pinion nut, thereby releasing tension the crush sleeve, a new one must be put in to place to ensure the correct torque setting (and tension) on the pinion nut. If you’re replacing the pinion seal, then you must also replace the crush sleeve and be very careful to set the correct pinion pre-load. Too much pre-load, which is easy to do, will cause premature failure of the pinion bearings.
0 stars based on 0 reviews
By using our website, you agree to the usage of cookies to help us make this website better. Hide this message More on cookies »
← .    We are experiencing a high volume of emails, please be patient while we get caught up. . Hide